Two Stage Lift Table Technical Information

A. MECHANICAL:

1. Wheel and Dolly Set - A wheel and dolly set is used for moving empty lifts only and is available on lifts with minimum length platforms. The wheels and dolly tongue are mounted on the ends of the base frame.
2. Caster Wheels - Caster wheels are used for moving empty or loaded lifts with any size platform. Two wheels are swivel and two wheels are fixed. Caster wheels can be end mounted or side mounted which increases the lift lowered height by approximately 3", or the caster wheels can be mounted under the base frame which increases the lift lowered height by approximately 8".
3. Bevel Toe Guards - 8" bevel toe guards are required by OSHA for lifts recessed into the floor and increase the minimum platform width by 8" and length by 10".
4. End and Side Loading - Reduce the lift end and side loading capacities by 2% for every inch added to the standard minimum platform length or width. Reduce the end or side loading capacities by 33% if the loads are going to be rolled onto the platform when the lift is other than fully lowered.

B. ELECTRICAL:

1. Standard voltage is 230/60/3. The motor supplied with the lift will operate on 208, 220, 230, 240, 440, 460, 480/60/3.
2. While single phase operation is not generally recommended, 115/60/1 and 230/60/1 motors are available. (Consult the factory.)
3. If frequency of operation is greater than one full lift every four minutes (or five minutes if lift takes one minute or longer to raise fully) the motor may overheat.

OPTIONAL ACCESSORIES

A. MECHANICAL:

1. Any oversize platform without bevel toe guards
2. Any size platform with bevel toe guards included
3. Wheel and dolly set for moving empty lift
4. Caster wheels for moving loaded lift
5. Locking caster wheels

B. POWER UNITS (EXTERNAL):

1. Continuous running (3 phase only)
2. Air operated with manual valves
3. External single phase power unit with larger horsepower motor for 2000, 4000 and 6000 lbs. capacity lifts to provide lifting speed comparable to 3 phase power unit

C. ELECTRICAL:

1. Guarded foot switch
2. NEMA 4X pendant push button (included in price)
3. NEMA 1 wall mount push button
4. Up-Down selector switch (key operated)
5. Up-Down push button with key lockout
6. Limit switch loose
7. Limit switch mounted